servo_#_min_momentary (close while pressed).servo_#_max_momentary (open while pressed).The Newton Gripper can be controlled via the following button functions in QGC: If your software is out of date, please conduct a software update by following the instructions on the BlueROV2 Software Setup page. The following servo settings are available on ArduSub 3.5.3 and QGroundControl v3.2.4-BlueRobotics-Rev6 or newer. This allows to clips to rotate so you can find the threaded hole in the Enclosure Cradle (4” Series) easily. It is easier to install these screws if the clips are not fully tightened until all screws are through the clips and threading into the Enclosure Cradle (4” Series). Install the M3x16 screws through the clips and into the Enclosure Cradle (4” Series). Mount the Electronics Enclosure to the frame using the M3x16 screws so that the dome is on the same side as the front center panels (the center panels without the 3 large holes). Apply silicone grease to the two radial O-rings on the O-Ring Flange (4” Series) that is attached to the Electronics Tray then install the Watertight Enclosure (4” Series) with installed Dome End Cap to the O-Ring Flange (4” Series).Ģ. Reinstall 4” Watertight Enclosure onto ROV with the following steps:ġ.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |